Morinda clothing
Current location: Home»Morinda Int News Center » News and Information » News Center » Identification of textile fiber content promoted to national standards

Identification of textile fiber content promoted to national standards

Categories: News CenterStars: 3Stars Visit: - Release time: 2014-04-18 10:28:00
Font size:【 Large Middle Small Source: Editor: Author:

By the general administration of quality supervision, inspection and quarantine, the national standardization management committee jointly issued the identification of the textile fiber content of the national standard (GB/T29862-2013) will take effect on May 1st. Textile fiber content of identity, is one of the consumer cognition to its specification, is an important standard in the textile industry.

By the general administration of quality supervision, inspection and quarantine, the national standardization management committee jointly issued the identification of the textile fiber content of the national standard (GB/T 29862-2013) will take effect on May 1st. This is the new national standard on the basis of the original industry standards, according to the reality of the product and testing work, revised and upgrade. According to the law of the People's Republic of China standardization law stipulated in article 6, after the enforcement of the national standard, the textile industry standard of FZ/T 01053-2007 "textile fiber content of the logo" hereby nullified.

Textile fiber content of identity, is one of the consumer cognition to its specification, is an important standard in the textile industry. Labeling program based on previous test results, textiles and fiber content project unqualified amount accounted for about 70% of all unqualified textiles, most of them is because of the fiber content label non-standard unqualified. Textiles after the logo from the industry standard to national standards, the specific provisions of textile fiber content labeling requirements, marking principle, said method, judgement of allowable deviation and identifying compliance requirements.

Larger changes in the old and new standard is 7.4 clause, the old standard is "when the labels of some kind of fiber content is 15% 30% (filler), fiber content allowed deviation is 30% of the nominal value", and the new national standard for "when some kind of fiber content on the label was 10%, fiber content tolerance is 3%; when some kind of fiber content is 3%, actual content may not be 0. When some filler fiber content on the label was 20%, fiber content tolerance is 5%; when a filler fiber content is 5%, actual content may not be 0". New standard the fiber content label is more than 10% less than or equal to 15% (filler fiber content is more than 20% less than or equal to 30%) attributed to the range of allowable deviation value plus or minus 5%.

Inspection and quarantine institutions prompt each related enterprise, must get ready for work, earnestly study and understand the good new national standard of the points. After the enforcement of national standard, all in the domestic sales of textiles, the fiber content label must comply with the requirements of the standard; In foreign trade enterprise exports the European and American orders, its surface fabric fiber content of the logo is more important, once the detection and identification, will face the risk of return or compensation.